Dometic MANUAL REFRIGERATOR Instrucciones de operaciones

INSTALLATION ANDOPERATING INSTRUCTIONSREFRIGERATOR FOR LP-GAS AND ELECTRIC OPERATIONRM2454USA Corporate Office CANADAService Office 2320 Industrial Pa

10DESCRIPTION OF OPERATING MODESAUTO MODEWhen operating in the AUTO mode, the AUTO modeindicator lamp (D) will illuminate.The control system will auto

11! WARNINGWhen all the frost has melted, dry the interior of the re-frigerator with a clean cloth. Replace all food and set thethermostat to the COLD

12MAINTENANCE & SERVICEThe user should be aware of service that must bedone on a regular schedule to keep the refrigeratoroperating properly. The

13C. Check the AMES control system by connecting/dis-connecting 120 volt AC power, start/stop the engine,etc. Compare the operation with the operation

14H. LP gas pressure low at burner.Set main regulator so pressure does not dropbelow 11 inches of water column at pressure testport. (See FIG. 12).I.

15CERTIFIED VENT SYSTEM KITSREFRIGERATOR KITMODEL NO. COMPONENTS PART NO.RM 2454 3A Roof Base 3103633.XXX*Roof Cover 3103634.XXX*Lower Side Vent 31093

16MO-FO 0413RM 2454

3Refrigerator control panelFIG. 2ONOFFACDCGASAUTOCHECKCOLD12345COLDESTLEGEND 3-WAY AMES Model1. Main Power Button ON/OFF2. DC Mode Selector Button3. A

4INSTALLATIONGENERAL INSTRUCTIONThis appliance is designed for storage of foods andstorage of frozen foods and making ice.This appliance is certified

5VENTILATION HEIGHTSRefer to FIG. 3 page 4.CLEARANCESMinimum clearances in inches to combustible materialsare:G: Top 0K: Side 0L: Bottom 0M: Rear 0N:

6INSTALLING REFRIGERATOR INENCLOSURENOTE: DO NOT install the appliance directly oncarpeting. Carpeting must be removed orprotected by a metal or wood

7Replace the top decoration panel. Be careful not to pinchthe wires behind the panel.Make sure the tabs snap back into the holes in the hingeplate.STE

8ELECTRICAL CONNECTION120 Volts AC ConnectionThe refrigerator is equipped with a three-prong (ground-ing) plug for your protection against shock hazar

9DC MODE1. Press the DC mode indicator button (2) to turn ONthe DC lamp (A).2. Press the TEMPERATURE SELECTOR button (4)until the lamp at the desired